Hi Expert,
Would you help me understand in which case 'Change Pending' in a Part is set?
In editing mode (state of a part is Preliminary), I can't untick it.
Thank you.
Hi,
the Changes Pending checkbox cannot be set by the user. The checkbox is set when the corresponding Item is used in a Change Process.
These two Methods do the job:
PE_clean_has_change_pending_prop
PE_update_has_change_pending
With "Where Used" you can see, that these Methods are used in ItemType Server Events. But beware - that´s only half the truth. Most of the time, these Methods are triggered by LifeCycle transistions.
These two Methdos trigger the checkbox update quite often:
PE_OnChangeItemReleased
PE_ChangeItemTransition
When you create a custom change process, you must extend these two with your own functions.
Hi,
the Changes Pending checkbox cannot be set by the user. The checkbox is set when the corresponding Item is used in a Change Process.
These two Methods do the job:
PE_clean_has_change_pending_prop
PE_update_has_change_pending
With "Where Used" you can see, that these Methods are used in ItemType Server Events. But beware - that´s only half the truth. Most of the time, these Methods are triggered by LifeCycle transistions.
These two Methdos trigger the checkbox update quite often:
PE_OnChangeItemReleased
PE_ChangeItemTransition
When you create a custom change process, you must extend these two with your own functions.